LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front oil level indicator and tube bolt.
    • To install, tighten to 25 N.m (18 lb-ft).
  2. Remove the rear oil level indicator and tube bolt.
    • To install, tighten to 10 N.m (89 lb-in).
  3. Remove the oil level indicator and tube from the cylinder block.
    • Discard the O-ring seal.
    4. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals