LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 953 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Heated Oxygen Sensor (HO2S) >> Removal

Heated Oxygen Sensor (HO2S): Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
  3. Using the special tool, remove the HO2S.
    • Apply penetrating lubricant to the HO2S to assist in removal.
    4. Fig 1: Identifying HO2S Special Tool
    G03922527Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals