Starter Motor: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: When performing maintenance on the starting system, be aware heavy gauge leads are connected to the battery. Make sure protective caps are in place when maintenance is complete. Failure to follow these instructions may result in personal injury.

Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
Remove the starter solenoid protective cap.

Fig 1: Identifying Starter Motor Solenoid Protective Cap

Courtesy of FORD MOTOR CO.

Label and disconnect the starter motor electrical connections.

Fig 2: Locating Starter Mounting Bolts

Courtesy of FORD MOTOR CO.

Remove the 2 top starter mounting bolts.
Remove the lower starter bolt and the starter.