LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 941 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Stabilizer Bar and Link >> Removal And Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove and discard the stabilizer bar link lower nuts and washers.
    • To install, tighten to 103 Nm (76 lb-ft).
  3. Remove and discard the stabilizer bar link upper nuts and washers and remove the stabilizer bar links.
    • To install, tighten to 62 Nm (46 lb-ft).


  1. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals