LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Driveshaft -- F250-F550 Super Duty) >> Removal And Installation >> Driveshaft - Rear, One-Piece, Rear Wheel Drive (RWD) >> Removal >> Vehicles with circular flange

Vehicles with circular flange

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: It may be necessary to tap the driveshaft yoke with a plastic or rubber soft-faced hammer if a pry area is not present on the driveshaft yoke.
    Fig 1: Locating 4 Flange Bolts
    GF0006224Courtesy of FORD MOTOR CO.
  1. Remove and discard the 4 flange bolts.
scientia non olet · About LEMON Manuals