LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Front Slip Yoke >> Disassembly >> Initial disassembly

Initial disassembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not, under any circumstance, clamp the shaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing shaft failure during vehicle operation.
  1. Place the shaft on a suitable workbench. Do not damage the tube.
  2. Remove and discard 2 snap rings.
    3. Fig 1: Locating Snap Ring
    G03883359Courtesy of FORD MOTOR CO.
  3. Clamp the special tool in a vise.
    4. Fig 2: Clamping Special Tool In Vise
    G03883356Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals