LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 933 (Front Disc Brake System - F250-F550 Super Duty) >> Removal And Installation >> Front Disc Brake >> Removal >> Dual rear wheel vehicles

Dual rear wheel vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hub extender nuts and the hub extender.
    2. NOTE: If the brake disc cannot be removed easily, apply penetrating and lock lubricant on the brake disc-to-wheel hub mating surface.
  2. Mark the hub extender stud and the corresponding brake disc extender stud hole.
    • This helps make sure the lowest front brake disc runout is maintained during reassembly.
    3. Fig 1: Marking Hub Extender Stud And Corresponding Brake Disc Extender Stud Hole
    GF0006166Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals