LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 933 (Front Disc Brake System - F250-F550 Super Duty) >> Removal And Installation >> Front Brake Caliper >> Installation

Front Brake Caliper: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Tighten the bottom caliper bolt before tightening the top caliper bolt.
    CAUTION: Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.
  1. Position the brake caliper and install the 2 brake caliper bolts.
    • On F-250, F-350, tighten to 76 Nm (56 lb-ft).
    • On F-450, F-550, tighten to 63 Nm (46 lb-ft).
  2. Using 2 new copper washers, position the brake flexible hose and install the brake caliper flow bolt.
    • Tighten to 48 Nm (35 lb-ft).
  3. Bleed the brake caliper. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.
  4. Test the brake system for normal operation.
scientia non olet · About LEMON Manuals