DTC P1130: Lack of HO2S-11 Switch, Fuel Trim at Limit

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.

P1130 - LACK OF HO2S-11 SWITCH, FUEL TRIM AT LIMIT

Description:	The heated oxygen sensor (HO2S) is monitored for switching. The test fails when the HO2S does not switch due to circuit or fuel at or exceeding a calibrated limit.
Possible Causes:	Electrical: Short to VPWR in the harness or HO2S Water in the harness connector Open/shorted HO2S circuit Corrosion or poor mating terminals and wiring Damaged HO2S Damaged powertrain control module (PCM) Fuel System: Excessive fuel pressure Leaking/contaminated fuel injectors Leaking fuel pressure regulator Low fuel pressure or running out of fuel Vapor recovery system Induction System: Air leaks after the mass air flow (MAF) sensor Vacuum leaks PCV system Improperly seated engine oil dipstick EGR System: Leaking gasket Stuck EGR valve Leaking diaphragm or EVR Base Engine: Oil overfill Camshaft timing Cylinder compression Exhaust leaks before or near the HO2S
Diagnostic Aids:	A fuel control HO2S PID switching across 0.45 volt from 0.2 to 0.9 volt indicates a normal switching HO2S.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	-	-	GO to H: Fuel Control STEP H16.