Transmission Fluid Cooler Tubes: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

If not done previously, carry out the transmission fluid cooler flow test procedure. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 4R70E/4R75E article.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the bolts and the skid plate (four wheel drive [4WD] vehicles).

Fig 1: Locating Skid Plate And Bolts

Courtesy of FORD MOTOR CO.

Remove the fasteners and position the air deflector aside.

Fig 2: Locating Fasteners

Courtesy of FORD MOTOR CO.

Disconnect the fluid cooler tubes from the transmission case.
Remove the secondary latches from the fluid cooler tubes.
Remove the fluid cooler tubes from the bracket.
Remove the cooler tubes from the retainer.
Using the special tool, disconnect the fluid cooler tubes from the radiator, and if equipped, the fluid cooler.

Fig 3: Locating Fluid Cooler Tubes And Special Tool

Courtesy of FORD MOTOR CO.