LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 916 (Anti-Lock Brake System - F150 & Mark LT) >> Removal And Installation >> Wheel Speed Sensor - Front, Four Wheel Drive (4WD) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
  4. Remove the wheel speed sensor harness from the pushpin retainer.
    5. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
  5. Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
    • Support the brake caliper anchor plate assembly using mechanic's wire.
    • To install, tighten to 112 Nm (83 lb-ft).
    6. NOTE: Index-mark the brake disc and wheel hub flange before removing the brake disc.
  6. Remove the brake disc.
  7. Remove the bolt and the wheel speed sensor.
    • To install, tighten to 8 Nm (71 lb-in).
  8. To install, reverse the removal procedure.
    • Apply brakes several times to verify correct brake operation.
scientia non olet · About LEMON Manuals