LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 894 (Supplemental Inflatable Restraint System - F-150 & Mark LT) >> General Procedures >> Pyrotechnic Device Disposal >> Driver Air Bag Module, Passenger Air Bag Module and Seat Side Air Bag Modules - Remote Deployment >> All driver, passenger and seat side air bag modules

All driver, passenger and seat side air bag modules

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make a container to house the air bag module for deployment.
      NOTE: The tires must be of sufficient size to accommodate the air bag module.
    • Obtain a tire and wheel assembly and an additional 4 tires (without wheels) of the same size.
    • With the tire and wheel assembly on the bottom, stack the tires.
    • Securely tie all of the tires together.
    2. Fig 1: Making Container To House Air Bag Module For Deployment
    G03926249Courtesy of FORD MOTOR CO.
  2. Depower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.
  3. Remove the air bag module. For additional information, refer to the appropriate procedure in this article.
    4. NOTE: If the air bag module does not have a hard-wired pigtail, it will be necessary to cut the wires and connector(s) from the vehicle wire harness and reconnect to the air bag module.
  4. Cut each of the air bag module wires near the electrical connector that connects to the vehicle wire harness.
  5. Remove any sheathing (if present) and strip the insulation from the ends of the cut wires.
    6. NOTE: Typical driver air bag module with 2 squibs shown, other air bag modules with multiple squibs similar.
  6. For air bag modules with multiple squibs, twist together a wire from each squib then repeat for the remaining wires from each squib.
    7. Fig 2: Locating Air Bag Module Wire Squibs
    G03959595Courtesy of FORD MOTOR CO.
  7. Make a jumper harness to deploy the air bag module.
    • Obtain 2 wires (20 gauge minimum) at least 9.14 m (30 ft) long and strip both ends of each wire.
    • At one end of the jumper harness, connect the wires together.
  8. Using the end of the jumper harness that the wires are not connected together, attach each wire of the jumper harness to each wire of the air bag module or to the twisted-together wires if multiple squibs. Use tape or other insulating material to make sure that the leads do not make contact with each other.
Fig 3: Connecting Jumper Wires To Squibs
G03959596Courtesy of FORD MOTOR CO.


  1. Remain at least 9.14 m (30 ft) away from the air bag module.
  2. From the end of the jumper harness that is not connected to the air bag module, disconnect the 2 wires of the jumper harness from each other.
  3. Deploy the air bag module by touching the ends of the 2 wires of the jumper harness to the terminals of a 12-volt battery.
  4. To allow for cooling, wait at least 10 minutes before approaching the deployed air bag module.
  5. Dispose of the deployed air bag module in the same manner as any other part to be scrapped.
scientia non olet · About LEMON Manuals