Passenger seat
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure the OCS system components are connected and no faults are present.
- Make sure the OCS system is not at a temperature below 0°C (32°F) or above 45°C (113°F) when initiating the reset process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within the limits, 0°C to 45°C (32°F to 113°F) for a minimum of 30 minutes.
- Make sure nothing is present on the passenger seat before carrying out the OCS system reset process and nothing is placed on the seat during the reset process.
- Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the reset process.
- Carry out the occupant classification sensor (OCS) reset active command using a scan tool.
- With the front passenger seat empty, use a diagnostic tool to trigger the active command.
- Cycle the ignition switch from ON to OFF.
CAUTION:
Make sure the seat is completely assembled before carrying out the OCS system reset.
CAUTION:
The following precautions must be taken before carrying out the OCS system reset:
NOTE:
For best results, the OCS system should be at or near room temperature, 10°C to 29°C (50°F to 85°F).
NOTE:
If the first attempt to reset the OCS system is unsuccessful, a second attempt must be made.
NOTE:
The ignition switch must be cycled after carrying out the OCS system reset.
NOTE:
The ignition switch must be cycled after carrying out the OCS system reset.