Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Programmable module installation (PMI) only needs to be carried out if the DVD player is being replaced.
- Upload the DVD player configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
- Remove the 4 screws.
- Remove the DVD player.
- Pull down on the sides of the DVD player to disengage the clips from the bracket.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
NOTE:
Open the DVD player display to access the screws.