All vehicles
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- For Regular and SuperCab vehicles, remove the headliner. For SuperCrew vehicles, lower and position the headliner forward. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
- Remove the rear trim panel pin-type retainers.
- Remove the rear trim panel.
- If equipped, disconnect the heated rear backlight connectors.
- Remove the rear window glass nuts.
- Remove the rear glass from the vehicle.
CAUTION:
Use only a plastic windshield setting tool to slide under the seal to separate the foam core butyl from the glass. Once the glass starts to separate from the body, constant hand pressure will break the seal and the glass can be removed. The aid of an assistant will be required to support the glass during this step to prevent damage to the glass frame, body or power sliding window cables, (if equipped). Failure to use a plastic windshield setting tool can damage the body or the glass frame.
NOTE:
If equipped with power sliding rear window, the glass must be supported in close proximity to the body during the following power sliding rear window removal steps.