All vehicles
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Apply foam core butyl to the window. Overlap the foam core butyl by 25 mm (1 in) at the bottom middle of the rear window glass.
NOTE:
Remove as much of the foam core butyl as possible from the body and window glass prior to installation.
- Carefully install the rear window glass into the body opening.
- Install the rear window glass nuts.
- Tighten to 4 Nm (35 lb-in).
- If equipped, connect the heated rear backlight electrical connectors.
- Install the rear trim panel.
- Install the rear trim panel pin-type retainers.
- For Regular and SuperCab vehicles, install the headliner. For SuperCrew vehicles, raise and reposition the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.