LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 869 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the mating surface.
    2. NOTE: Lubricate the crankshaft rear seal lips with clean engine oil prior to installation.
    Fig 1: Identifying Special Tools And Crankshaft Rear Seal
    GF0002441Courtesy of FORD MOTOR CO.
  2. Assemble the special tools and the crankshaft rear seal.
  3. Install the special tools on the rear of the crankshaft.
    Fig 2: Installing Special Tools On Rear Of Crankshaft
    GF0002442Courtesy of FORD MOTOR CO.
  4. Install the crankshaft rear seal. Tighten the center jack screw until the spacer contacts the engine block.
    Fig 3: Installing Crankshaft Rear Seal
    GF0002443Courtesy of FORD MOTOR CO.
  5. Install the flywheel or the flexplate. For additional information, refer to Flywheel  or Flexplate  in this article.
scientia non olet · About LEMON Manuals