Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
- Remove the upper intake manifold. For additional information, refer to ENGINE - 4.2L article.
- Disconnect the fuel charging wiring harness-to-main engine wiring harness electrical connector.
- Disconnect the intake manifold runner control (IMRC) actuator electrical connector.
- Disconnect the 6 fuel injector electrical connectors.
- Disconnect the 2 wiring harness retainers.
- Remove the wire tie.
- Disconnect the fuel rail pressure sensor electrical connector.
- Remove the fuel charging wiring harness.
- To install, reverse the removal procedure.