Oil Pump Screen and Pickup Tube: Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Position the oil pump screen and pickup tube and install the bolts.
- Tighten the oil pump screen and pickup tube-to-oil pump bolts to 10 N.m (89 lb-in).
- Tighten the oil pump screen and pickup tube-to-spacer bolt to 25 N.m (18 lb-ft).
- Install the oil pan. For additional information, refer to Oil Pan in this article.
CAUTION:
Make sure the O-ring is in place and not damaged. A missing or damaged O-ring can cause foam in the lubrication system, low oil pressure and severe engine damage.
NOTE:
Clean and inspect the mating surfaces and install a new O-ring. Lubricate the O-ring with clean engine oil prior to installation.