RH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the RH exhaust manifold.
1. Remove and discard the nuts.
2. Remove the RH exhaust manifold.
3. Remove and discard the RH exhaust manifold gasket.
- Inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Fig 1: Locating Exhaust Manifold Gasket
Courtesy of FORD MOTOR CO.
Remove and discard the 8 RH exhaust manifold-to-cylinder head studs.

Fig 2: Locating RH Exhaust Manifold-To-Cylinder Head Studs

Courtesy of FORD MOTOR CO.

Disconnect the coolant hoses from the heater outlet tube.

Fig 3: Disconnecting Coolant Hoses From Heater Outlet Tube

Courtesy of FORD MOTOR CO.

Remove the heater outlet tube studs.

Fig 4: Locating Heater Outlet Tube Studs

Courtesy of FORD MOTOR CO.

Remove the heater outlet tube and discard the O-ring seal.

Fig 5: Locating Heater Outlet Tube

Courtesy of FORD MOTOR CO.