LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine - 4.6L (2V) - F-150) >> In-Vehicle Servicing >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The 3 rearmost valve seals on the RH side must use special tool 303-567 in the same manner as is shown in the illustration.
    NOTE: Lubricate the valve seal with clean engine oil prior to installation.
  1. Using the special tools, install the new valve stem seal.
    2. Fig 1: Locating Valve Stem Seal
    GF0002629Courtesy of FORD MOTOR CO.
  2. Install the valve springs. For additional information, refer to Valve Springs  in this article.
scientia non olet · About LEMON Manuals