LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine - 4.6L (2V) - F-150) >> In-Vehicle Servicing >> Exhaust Manifold - RH >> Removal

Exhaust Manifold - RH: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the starter. For additional information, refer to STARTING SYSTEM article.
  3. Remove the RH inner fenderwell. For additional information, refer to FRONT END BODY PANELS article.
  4. Remove the 2 exhaust Y-pipe flange nuts and position the exhaust Y-pipe flange aside.
  5. Remove and discard the 8 exhaust manifold nuts.
  6. Remove the RH exhaust manifold and discard the gasket.
  7. Remove and discard the 8 exhaust manifold-to-cylinder head studs.
  8. Inspect the exhaust manifold for flatness. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals