LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Engine - 4.6L (2V) - F-150) >> In-Vehicle Servicing >> Exhaust Manifold - LH >> Removal

Exhaust Manifold - LH: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the LH inner fenderwell. For additional information, refer to FRONT END BODY PANELS article.
  3. Remove the 2 exhaust Y-pipe flange nuts and position the exhaust Y-pipe flange aside.
  4. Remove the exhaust gas recirculation (EGR) system module-to-exhaust manifold tube.
  5. Remove and discard the 8 exhaust manifold nuts.
  6. Remove the LH exhaust manifold and discard the gasket.
  7. Remove and discard the 8 exhaust manifold-to-cylinder head studs.
  8. Inspect the exhaust manifold for flatness. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals