Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cooling fan shroud. For additional information, refer to ENGINE COOLING article.
Rotate the tensioner clockwise and remove the drive belt.

Fig 1: Rotating Tensioner Clockwise

Courtesy of FORD MOTOR CO.

CAUTION: This bolt is torque-to-yield and cannot be reused.

Using the special tool, remove the bolt and washer and discard the bolt.

Fig 2: Removing Bolt And Washer Using Special Tool

Courtesy of FORD MOTOR CO.

Using the special tool, remove the crankshaft pulley.

Fig 3: Removing Crankshaft Pulley Using Special Tool

Courtesy of FORD MOTOR CO.