Rear Brake Pads: Removal
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Check the brake fluid level in the brake master cylinder reservoir.
- If required, remove fluid until the brake master cylinder reservoir is half full.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the 2 brake caliper guide pin bolts and position the brake caliper aside.
- Support the caliper using mechanic's wire.
- Measure the brake disc thickness and install a new brake disc if it is not within specification.
- Remove the brake pads and the 2 spring clips.
- Discard the spring clips.
- Inspect the pads for wear and contamination.
- Inspect the brake caliper anchor plate assembly.
- Check the guide pin boots for damage.
- Check the guide pins for binding and damage.
- Replace worn or damaged boots. Lubricate the guide pins.
CAUTION:
Do not allow the brake caliper to hang from the brake hose or damage to the hose can result.
CAUTION:
Install a new pad if it is worn past the specified thickness above the metal backing plate or rivets. Install new pads in complete axle sets.