P0010 - Intake Camshaft Position Actuator Circuit/Open (Bank 1)
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0010 - INTAKE CAMSHAFT POSITION ACTUATOR CIRCUIT/OPEN (BANK 1)
| Description: | The powertrain control module (PCM) monitors the variable camshaft timing (VCT) circuit to the PCM for high and low voltage. The test fails if the voltage exceeds or falls below a calibrated limit for a calibrated amount of time. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | This DTC is a circuit check. Testing should include the harness and solenoid coil. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST HK . | |||