A-Pillar Trim Panel
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure is for vehicles equipped with side air curtains. On vehicles without side air curtains, the A-pillar trim panel is easier to remove and the retainers are reusable.
NOTE:
The A-pillar trim panel is held in place by a clip that is snapped to the back of the panel. When installing the existing trim panel a new clip must be installed.
- Remove the A-pillar trim panel and the clip from the sheet metal.
- Use a new A-pillar trim panel clip when installing.
- To install, reverse the removal procedure.
- Align attachment clips to the holes and snap in place.
NOTE:
When removing the A-pillar trim panel, use a gentle side-to-side rocking motion to free the clip from the trim panel.