LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 822 (Bumpers) >> Removal And Installation >> Bumper Cover - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the rear lamp assembly. For additional information, refer to EXTERIOR LIGHTING .
  2. Remove the 6 pin-type retainers (3 each side) from the rear splash shield.
  3. Remove the 2 pin-type retainers from the lower rear bumper cover.
    Fig 1: Locating Pin-Type Retainers From Lower Rear Bumper Cover
    G04683809Courtesy of FORD MOTOR CO.
  4. Remove the 2 bolts and 2 pin-type retainers from the top of the rear bumper cover.
    1. Remove the 2 bolts (1 shown).
    2. Remove the 2 pin-type retainers (1 shown).
      Fig 2: Identifying Pin-Type Retainers And Bolts
      G04683810Courtesy of FORD MOTOR CO.
  5. Remove the 2 upper bumper cover screws (1 each side).
  6. If equipped, disconnect the parking aid system electrical connector.

    7. Milan and Zephyr only 

  7. Disconnect the license plate lamp electrical connector.
  8. Remove the rear bumper cover.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals