Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front bumper cover. For additional information, refer to BUMPER COVER - FRONT .
- Remove the front bumper isolator from the front bumper.
- Pull the isolator rearward while releasing the retainers.
- Remove the 6 front bumper bolts (3 each side).
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the 4 front bumper bolts from the radiator support (2 each side).
- Remove the 2 front bumper stud nuts.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the front bumper.
- To install, reverse the removal procedure.