Intermediate Shaft Speed Sensor: Removal

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the intermediate shaft speed sensor electrical connector.

Fig 1: Locating Intermediate Shaft Speed Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolt and the intermediate shaft speed sensor.
- To install, tighten to 10 Nm (89 lb-in).
- Check the sensor bore.
- Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.
  
  Fig 2: Locating Intermediate Shaft Speed Sensor Bolt
  Courtesy of FORD MOTOR CO.