Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the upper cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
Disconnect the windshield wiper motor electrical connector.
Remove the 2 windshield wiper mounting arm and pivot shaft assembly bolts and the windshield wiper mounting arm and pivot shaft assembly.
- To install, tighten to 5 Nm (44 lb-in).
  
  Fig 1: Locating Pivot Shaft Assembly Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.