LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 803 (Seating) >> Removal And Installation >> Seat Backrest Cover - Rear, 40 Percent >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion. For additional information, refer to SEAT CUSHION - REAR .
  2. Remove the 40 percent rear seat backrest. For additional information, refer to SEAT BACKREST - REAR .
  3. Release the lower J-strip, 4 J-clips and remove the staples from each side.
    4. CAUTION: Use care when separating the backrest trim cover from the hook and loop strip, or the hook and loop strip can be torn from the backrest foam pad.
  4. Partially invert the trim cover separating the hook and loop strips and remove the first row of hog rings.
  5. Continue to invert the backrest trim cover separating the hook and loop strips and removing all rows of hog rings working up the backrest.
  6. Remove the backrest trim cover.
  7. To install, reverse the removal procedure.
  8. Install the 40 percent rear seat backrest assembly. For additional information, refer to SEAT BACKREST - REAR .
  9. Install the rear seat cushion. For additional information, refer to SEAT CUSHION - REAR .
scientia non olet · About LEMON Manuals