Pinpoint Test G: The Power Seat Does Not Make Full Travel

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

G1 CHECK FOR AN OBSTRUCTION IN THE SEAT TRACK
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in injury and possible violation of vehicle safety standards.

NOTE: If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered. Refer to SUPPLEMENTAL RESTRAINT SYSTEM .

NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Key in OFF position.
- For vehicles equipped with seat side air bags, carry out the following:
  - Depower the SRS. Refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
  - Disconnect the affected seat side air bag C327 (driver) or C313 (passenger).
  - Connect restraint system diagnostic tool 418-133 to the affected seat side air bag C327 (driver) or C313 (passenger).
  - Connect the battery ground cable.
- Remove the affected seat. Refer to SEAT - FRONT .
- Are there any obstructions in the track?
Yes : REMOVE the obstruction(s) and GREASE the track(s). TEST the system for normal operation.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. DISCONNECT the restraint system diagnostic tool from seat side air bag module C327 (driver) or C313 (passenger) and CONNECT seat side air bag module C327 (driver) or C313 (passenger). REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .

No : IDENTIFY the cause and INSTALL a new seat track component. TEST the system for normal operation.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. DISCONNECT the restraint system diagnostic tool from seat side air bag module C327 (driver) or C313 (passenger) and CONNECT seat side air bag module C327 (driver) or C313 (passenger). REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .