Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Make sure the parking brake control is in the released position.
- Disconnect the warning indicator switch electrical connector.
- Loosen the parking brake control adjusting nut.
- Remove the 2 parking brake control nuts.
- To install, tighten to 20 Nm (15 lb-ft).
- Remove the parking brake control bolt and the parking brake control.
- To install, tighten to 20 Nm (15 lb-ft).
- To install, reverse the removal procedure.
- Adjust the parking brake cable. For additional information, refer to PARKING BRAKE CABLE ADJUSTMENT .