Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear door module. For additional information, refer to WINDOW REGULATOR AND MOTOR - REAR DOOR .
Remove the access hole plug.

Fig 1: Locating Access Hole Plug
Courtesy of FORD MOTOR CO.
Remove the bolt and the screw.

Fig 2: Locating Bolt And Screw
Courtesy of FORD MOTOR CO.
Remove the inner beltline weatherstrip.

Fig 3: Locating Inner Beltline Weatherstrip
Courtesy of FORD MOTOR CO.
Remove the screw and the outer beltline weatherstrip.

Fig 4: Locating Outer Beltline Weatherstrip
Courtesy of FORD MOTOR CO.
Position the rear window glass run aside.

Fig 5: Identifying Rear Window Glass Position
Courtesy of FORD MOTOR CO.
Remove the rear quarter window glass.

Fig 6: Identifying Rear Quarter Window Glass
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.