Pinpoint Test E: One High Beam Headlamp Is Inoperative

WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The ignition switch must be cycled from OFF to RUN to enable the SSP feature.

Fig 1: Pinpoint Test E: One High Beam Headlamp Is Inoperative (Step E1)

Courtesy of FORD MOTOR CO.

Fig 2: Pinpoint Test E: One High Beam Headlamp Is Inoperative (Steps E2-E3)

Courtesy of FORD MOTOR CO.

Fig 3: Pinpoint Test E: One High Beam Headlamp Is Inoperative (Steps E4-E5)

Courtesy of FORD MOTOR CO.

Fig 4: Pinpoint Test E: One High Beam Headlamp Is Inoperative (Steps E6-E7)

Courtesy of FORD MOTOR CO.

Fig 5: Pinpoint Test E: One High Beam Headlamp Is Inoperative (Steps E8-E9)

Courtesy of FORD MOTOR CO.