Inspection and Verification
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION TABLE
Mechanical Electrical - Fuel tank
- Low engine coolant level
- Accessory drive belt
- Low engine oil level
- Low brake fluid level
- Low washer fluid level
- Tires
- Smart junction box (SJB) fuse(s):
- 22 (7.5A)
- Instrument cluster
- Switches or sensors
- Circuitry
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the concern is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
- Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
- CAN or ISO circuit fault; all electronic control units no response/not equipped, refer to PINPOINT TEST L: NO INTERNATIONAL STANDARDS ORGANIZATION (ISO) 9141 COMMUNICATIONS NETWORK COMMUNICATION .
- No response/not equipped for the instrument cluster, refer to PINPOINT TEST A: NO COMMUNICATION WITH THE INSTRUMENT CLUSTER .
- System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out self-test diagnostics for the instrument cluster.
- If the DTCs retrieved are related to the concern, refer to the INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
- If no DTCs related to the concern are retrieved, GO to SYMPTOM TABLE .INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) INDEX
DTC Description Source Action B1205 IC Switch 1 Assembly Circuit Failure Instrument cluster GO to PINPOINT TEST D . B2097 Compass Module Failure Instrument cluster GO to PINPOINT TEST B . U2013 Compass Module Not Responding Instrument cluster GO to PINPOINT TEST B . All Other DTCs - Instrument cluster REFER to INSTRUMENT CLUSTER .