LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 715 (Parking Brake System & Actuation) >> Removal And Installation >> Parking Brake Cable - Intermediate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Relieve the parking brake cable tension. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE  .
  2. Remove the 3 parking brake cable bracket bolts from the subframe.
    • To install, tighten to 12 N.m (9 lb-ft).
  3. Disconnect the intermediate cable from the front cable at the cable-to-cable union.
  4. Release the intermediate cable from the body bracket.
  5. Release the intermediate cable from the rear RH cable at the cable-to-cable union.
  6. Release the LH rear cable from the intermediate cable at the conduit equalizer.

    7. Early build vehicles 

  7. Remove the wireform bracket bolt on top of the subframe and remove the intermediate parking brake cable.
    • To install, tighten to 18 N.m (13 lb-ft).

    8. All vehicles 

  8. Remove the wireform bracket bolt on top of the subframe and remove the intermediate parking brake cable.
    • To install, tighten to 18 N.m (13 lb-ft).
scientia non olet · About LEMON Manuals