LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 706 (Rear Drive HALFSHAFTS) >> Removal And Installation >> Halfshaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the tire and wheel assembly. For additional information, refer to REMOVAL .
    3. CAUTION: To prevent damage to the brake hose, do not allow the disc brake caliper to hang suspended from the hose.
  3. Remove the disc brake caliper anchor bolts, then the disc brake caliper and anchor as an assembly. Using mechanics wire, support the disc brake caliper and anchor as an assembly.
    • To install, tighten to 110 N.m (81 lb-ft).
    4. CAUTION:
    1. The rear axle wheel end nut is a torque prevailing design nut. Do not reuse the rear axle wheel end nut.
    2. Install and tighten the new rear axle wheel end nut to specification in a continuous rotation. Stopping the rotation during installation will cause the nylon lock to seat incorrectly. This will cause incorrect torque readings while tightening the rear axle wheel end nut and lead to bearing failure. Always install a new rear axle wheel end nut after loosening or when not tightened to specifications in a continuous rotation.
  4. Remove and discard the rear axle wheel end nut.
    • To install, tighten to 200 N.m (148 lb-ft).
  5. Remove the anti-lock sensor bolt. Disconnect the anti-lock sensor from the hub.
    • To install, tighten to 14 N.m (10 lb-ft).
    Fig 1: Removing Anti-Lock Sensor Bolt
    G04655440Courtesy of FORD MOTOR CO.
  6. Using a suitable hub remover, press the half shaft until loose in the hub.
    Fig 2: Identifying Special Tool
    G04655441Courtesy of FORD MOTOR CO.
  7. Remove the brake disc screw and the brake disc.
    • To install, tighten to 21 N.m (16 lb-ft).
  8. Remove the 4 hub bolts, then remove the hub.
    • To install, tighten to 120 N.m (89 lb-ft).
  9. Using a prybar, carefully separate the halfshaft from the axle.
  10. Remove the halfshaft.
    11. CAUTION:
    • Install a new circlip every time the halfshaft is removed from the axle.
    • The rear axle wheel end nut is a torque prevailing design nut. Do not reuse the rear axle wheel end nut.
    NOTE: Start one end of the circlip in the groove and work the circlip over the halfshaft and into the groove to prevent the circlip from overexpanding.
    Fig 3: Locating Halfshaft Circlip
    G03972275Courtesy of FORD MOTOR CO.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals