LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 690 (HVAC Control System) >> Removal And Installation >> Auxiliary Coolant Flow Pump >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner and air cleaner outlet tube. For additional information, refer to REMOVAL AND INSTALLATION and REMOVAL AND INSTALLATION .
  2. Using suitable tools, clamp off the heater hoses at the auxiliary coolant flow pump.
  3. Release the 2 hose clamps and disconnect the hoses from the auxiliary coolant flow pump.
  4. Remove the LH auxiliary coolant flow pump bolt.
    • To install, tighten to 7 N.m (62 lb-in).
    5. NOTE: The RH auxiliary coolant flow pump bolt is retained to the auxiliary coolant flow pump bracket with a clip, and will be removed with the auxiliary coolant flow pump as an assembly.
  5. Completely loosen the RH auxiliary coolant flow pump bolt.
    • To install, tighten to 7 N.m (62 lb-in).
  6. Disconnect the auxiliary coolant flow pump electrical connector.
  7. Remove the auxiliary coolant flow pump.
  8. To install, reverse the removal procedure.
    • Clean and lubricate the coolant hoses with plain water only, if needed.
  9. Fill the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals