LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 689 (Engine) >> In-Vehicle Repair >> Exhaust Manifold - RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the RH catalytic converter. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Disconnect the heated oxygen sensor (HO2S) electrical connector.
  4. Remove the 3 bolts and the RH exhaust manifold heat shield
    • To install, tighten to 11 N.m (8 lb-ft).
  5. Disconnect the exhaust gas recirculation (EGR) system module tube from the exhaust manifold.
    • To install, tighten to 40 N.m (30 lb-ft).
  6. Remove and discard the 6 RH exhaust manifold nuts.
    • To install, tighten to 20 N.m (15 lb-ft).
  7. Remove and discard the 3 studs closest to the rear of the cylinder head.
    • To install, tighten to 12 N.m (9 lb-ft).
  8. Remove the RH exhaust manifold and gasket.
    • Discard the exhaust manifold gasket.
  9. Remove and discard the 3 remaining studs.
    • To install, tighten to 12 N.m (9 lb-ft).
    10. NOTE: Make sure to install a new exhaust manifold gasket, studs and nuts.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals