LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Track - Bucket and 40 Percent >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat. For additional information, refer to SEAT - FRONT, BUCKET AND 40 PERCENT .
  2. Remove the safety belt buckle nut and disconnect the usage detection switch electrical connector, and remove safety belt buckle.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
      Fig 1: Locating Bolts
      G04646066Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 2: Disconnecting Electrical Connector
    G04646067Courtesy of FORD MOTOR CO.
  5. Remove the electrical harness pin-type retainer.
    Fig 3: Locating Electrical Harness Pin-Type Retainer
    G04646068Courtesy of FORD MOTOR CO.
  6. Disconnect the seat motor electrical connector.
    Fig 4: Disconnecting Seat Motor Electrical Connector
    G04646069Courtesy of FORD MOTOR CO.
  7. Remove the seat track.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals