Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the seat back. For additional information, refer to SEAT BACKREST - FRONT, BUCKET AND 40 PERCENT .
Release the J-clip.

Fig 1: Locating J-Clip
Courtesy of FORD MOTOR CO.
Remove the seat latch bolts and remove latch.
- To install, tighten to 50 Nm (37 lb-ft).
  
  Fig 2: Locating Seat Latch Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.