Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All seats

Remove the seat. For additional information, refer to SEAT - FRONT, BUCKET AND 40 PERCENT .
Remove the lumbar knob.

Fig 1: Locating Lumbar Knob
Courtesy of FORD MOTOR CO.
Remove the seat backrest lever.

Fig 2: Locating Seat Backrest Lever
Courtesy of FORD MOTOR CO.
Remove the screws.

Fig 3: Locating Screws
Courtesy of FORD MOTOR CO.
Remove the pin-type retainer.

Fig 4: Locating Pin-Type Retainer
Courtesy of FORD MOTOR CO.
Remove the screws.

Fig 5: Locating Screws
Courtesy of FORD MOTOR CO.
Remove the screws.

Fig 6: Locating Screws
Courtesy of FORD MOTOR CO.

Vehicles with heated seats

Disconnect heated seat switch electrical connector.

Fig 7: Locating Heated Seat Switch Electrical Connector
Courtesy of FORD MOTOR CO.

All seats

Disconnect the electrical connector and remove the seat control switch.

Fig 8: Disconnecting Seat Control Switch
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.