Seat Control Switch - With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the seat control switch and install 2 screws.

Fig 1: Locating Seat Control Switch
Courtesy of FORD MOTOR CO.
Connect the seat control switch electrical connector.

Fig 2: Locating Seat Control Switch Electrical Connector
Courtesy of FORD MOTOR CO.

NOTE: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Position the side trim cover. Install the 3 trim cover screws.
- The seat backrest pivot bolt shaft must be inserted into the cover standoff.
  
  Fig 3: Locating Seat Backrest Pivot Bolt Shaft And Cover
  Courtesy of FORD MOTOR CO.
Push the rearward lower corner of the side shield to engage the metal retaining clip.
Position the lumbar adjuster control. Install the 2 mounting screws. Install the adjuster knob.

Fig 4: Locating Mounting Screws
Courtesy of FORD MOTOR CO.
Position the seat back recliner lever cover. Install the screw.

Fig 5: Locating Seat Back Recliner Lever Cover
Courtesy of FORD MOTOR CO.
Install the front seat. For additional information, refer to SEAT - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR) .