Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear seat. For additional information, refer to SEAT - REAR, BENCH, CREWCAB .
Separate the seat cover J-clip.

Fig 1: Separating Seat Cover J-Clip
Courtesy of FORD MOTOR CO.
Pull the seat covering to access the seat back retaining bolts.

Fig 2: Pulling Seat Covering
Courtesy of FORD MOTOR CO.
Remove the seat back bolts.
- To install, tighten to 50 Nm (37 lb-ft).
  
  Fig 3: Locating Seat Back Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.