Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front bench seat. For additional information, refer to SEAT - FRONT, BENCH .
Release the RH hook and loop strip on the cushion flap.

Fig 1: Releasing RH Hook And Loop Strip On Cushion Flap
Courtesy of FORD MOTOR CO.
Release the RH J-clip.

Fig 2: Locating RH J-Clip
Courtesy of FORD MOTOR CO.
Release the RH recliner cable.
1. Release the cable anchor from the latch retainer.
2. Swivel the cable end and remove.
  
  Fig 3: Locating Cable Anchor From Latch Retainer
  Courtesy of FORD MOTOR CO.
Remove the RH cushion latch recliner bolts.
- To install, tighten to 50 Nm (37 lb-ft).
  
  Fig 4: Locating RH Cushion Latch Recliner Bolts
  Courtesy of FORD MOTOR CO.
Release the LH hook and loop strip on the cushion flap.

Fig 5: Releasing LH Hook And Loop Strip On Cushion Flap
Courtesy of FORD MOTOR CO.
Release the LH J-clip.

Fig 6: Locating LH J-Clip
Courtesy of FORD MOTOR CO.
Release the LH recliner cable.
1. Release the cable anchor from the latch retainer.
2. Swivel the cable end and remove.
  
  Fig 7: Identifying Cable Anchor From Latch Retainer
  Courtesy of FORD MOTOR CO.
Remove the backrest assembly.
1. Remove the recliner handle screw.
2. Remove the recliner handle.
3. Remove the LH cushion latch recliner bolts.
  - To install, tighten to 50 Nm (37 lb-ft).
4. Slide the backrest assembly rearward and remove the backrest assembly.
  
  Fig 8: Locating LH Cushion Latch Recliner Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.