LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat - Front, 20 Percent >> Removal

Seat - Front, 20 Percent: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: New bolts must be installed, do not reuse the bolts that were removed.
  1. Remove the front seats. For additional information, refer to SEAT - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR)  or SEAT - FRONT, BUCKET AND 40 PERCENT .
  2. Remove and discard the 20 percent seat riser-to-floor RH rear bolt.
    Fig 1: Locating Seat Riser-To-Floor RH Rear Bolt
    G04645988Courtesy of FORD MOTOR CO.
  3. Remove the 20 percent seat riser-to-floor LH rear nut.
    Fig 2: Locating Seat Riser-To-Floor LH Rear Nut
    G04645989Courtesy of FORD MOTOR CO.
  4. Remove the seat.

    Installation 

  1. Position the seat.
  2. Position the safety belt anchor. Install the 20 percent seat riser-to-floor LH rear nut.
    • Make sure the safety belt is not twisted prior to installation.
      • Tighten to 55 Nm (41 lb-ft).
  3. Install the new 20 percent seat riser-to-floor RH rear bolt.
    • Tighten to 55 Nm (41 lb-ft).
  4. Install the front seats. For additional information, refer to SEAT - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR)  or SEAT - FRONT, BUCKET AND 40 PERCENT .
  5. Make sure the safety belt and buckles are accessible to the occupants after installation.
scientia non olet · About LEMON Manuals