Disassembly and Assembly

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the seat backrest. For additional information, refer to SEAT BACKREST - REAR, BENCH, CREWCAB .
Remove the right and left seat risers (right side shown, left side similar).
- To install, tighten to 50 Nm (37 lb-ft).
  
  Fig 1: Locating Right And Left Seat Risers
  Courtesy of FORD MOTOR CO.

NOTE: Note location of spacers when removing for installation reference.

Remove the right and left seat spacers.
- To install, tighten to 50 Nm (37 lb-ft).
  
  Fig 2: Locating Right And Left Seat Spacers
  Courtesy of FORD MOTOR CO.
Unfasten the seat cushion cover J-strips and remove the seat cushion cover.

Fig 3: Locating Seat Cushion Cover
Courtesy of FORD MOTOR CO.
Remove the seat cushion foam pad from the seat frame.
To assemble, reverse the disassembly procedure.