LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 665 (Safety Belt System - F250-F550 Super Duty) >> Removal And Installation >> Child Safety Seat Tether Anchor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

    SuperCab vehicles 

  1. From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from the vehicle.
    Fig 1: Pushing Seat Backrest Upward
    G04646610Courtesy of FORD MOTOR CO.

    2. Regular cab vehicles 

  2. Position the front seat(s) FORWARD.

    3. Crew Cab vehicles 

  3. Position the rear seat backrest DOWN.

    4. Regular and Crew Cab vehicles 

    NOTE: RH side shown, all others similar.
  4. Remove the bolt and the child safety seat tether anchor.
    • To install, tighten to 30 Nm (22 lb-ft).
      Fig 2: Locating Child Safety Seat Tether Anchor Bolt
      G04646611Courtesy of FORD MOTOR CO.

    5. SuperCab vehicles 

    NOTE: RH side shown, all others similar.
  5. Remove the bolt and the child safety seat tether anchor.
    • To install, tighten to 30 Nm (22 lb-ft).
      Fig 3: Locating Safety Seat Tether Anchor Bolt
      G04646612Courtesy of FORD MOTOR CO.

    6. All vehicles 

    WARNING: It is important that the bolt/anchor be securely tightened to specification. Otherwise, the child's safety seat may not be correctly secured and the child can be injured in case of a sudden stop or accident.
    NOTE: For SuperCab, after seat backrest installation, make sure the child safety seat tether anchor strap is accessible and not trapped between the seat backrest and cab back panel.
  6. To install, reverse the removal procedure.
  7. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals